Leaflet

Setting the call details (continued...)
Some call details are configured at the endpoint.
For deployment with Cisco TelePresence Multipoint
Switch (CTMS), the recommended value is 2500 kbps
or higher.
The auto answer settings provisioned in Cisco Unified
CM are ignored by the endpoint and must be set on
the endpoint itself.
Setting the call details
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
When logged on to the endpoint through the command line
interface, run the following commands:
1. Configure the auto answering
xConfiguration Conference 1 AutoAnswer Mode:
<On/Off> [must be set locally on the endpoint]
xConfiguration Conference 1 AutoAnswer Mute:
<On/Off> [must be set locally on the endpoint]
xConfiguration Conference 1 AutoAnswer
Delay: <0..50> [must be set locally on the endpoint]
2. Configure the default call settings
xConfiguration Conference 1 DefaultCall
Rate: <64..6000> [when used with CTMS; 2500 kbps
or higher]
xConfiguration Conference 1 DefaultCall
Protocol: SIP [must be SIP for CUCM mode]
Setting the call details
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
When logged on to the endpoint through the web interface,
go to the Configuration tab and choose Advanced
Configuration. Then open the Conference 1 page from the
left sidebar.
1. Configure the auto answering
Go to the Auto Answer section and set appropriate
values for Delay, Mode and Mute.
Click Ok to save the change.
2. Configure the default call settings
Go to the DefaultCall section and set the Rate to the
appropriate value.
In Cisco UCM mode the Default Call Protocol is
automatically set to SIP, and H.323 is not supported.
Click Ok to save the change.
API WEB
Cisco TelePresence Endpoints running TC6 and Cisco Unified Communications Manager 9.0 Quick Reference Guide
D14996.01 Administering TC6 Endpoints on CUCM 9.0, January 2013. www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
12
Contents
Introduction
Endpoint configuration
CUCM configuration
Setting passwords
Appendices
Endpoint configuration