Leaflet

Setting the call details
Some call details are configured at the endpoint.
For deployment with Cisco TelePresence Multipoint
Switch (CTMS), the recommended value is 2500 kbps
or higher.
The auto answer settings provisioned in Cisco Unified
CM are ignored by the endpoint and must be set on
the endpoint itself.
Setting the call details
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
1. Configure the auto answering
Use the remote control and go to Home > Settings >
Administrator Settings > Advanced Configuration >
Conference 1 and set to IPv6.
Go to the Auto Answer section and set appropriate
values for Delay, Mode and Mute.
Click Ok to save the change.
2. Configure the default call settings
Use the remote control and go to the DefaultCall section
and set the Rate to the appropriate value.
In Cisco UCM mode the Default Call Protocol is
automatically set to SIP, and H.323 is not supported.
Click Ok to save the change.
Setting the call details
If in doubt for any of the parameters below, contact your
system administrator or your service provider.
On the Touch controller, tap More > Settings (
) >
Administrator Settings > Call Settings.
1. Configure the auto answering
Set Auto Answer to On or Off, and if appropriate set the
Auto Answer Delay. Tap the plus (+) or minus (-) buttons
to increase or decrease the value.
2. Configure the default call settings
Choose Call Rate and set the Default Call Rate to the
appropriate value. Tap the plus (+) or minus (-) buttons to
increase or decrease the value.
In Cisco UCM mode the Default Call Protocol is
automatically set to SIP, and H.323 is not supported.
Cisco TelePresence Endpoints running TC6 and Cisco Unified Communications Manager 9.0 Quick Reference Guide
D14996.01 Administering TC6 Endpoints on CUCM 9.0, January 2013. www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
11
Touch
OSD
Contents
Introduction
Endpoint configuration
CUCM configuration
Setting passwords
Appendices
Endpoint configuration