Manualshelf

Release Notes

ManualsBrandsCisco Manualsvideo conferencing systemsCisco TelePresence Server on Virtual Machine
21222324252627282930
Upgrading to 3.1(1.95)
Cisco TelePresence Server Software Release Notes 3.1(1.95) Page 29 of 31
Downgrade instructions
If you need to reverse your upgrade, you can re-install the former version of the software. The downgrade
procedure is the same as the upgrade procedure except you will use the earlier software image.
CAUTION:Make sure that all relevant backup processes described in Prerequisites [p.27] have been
completed before you start the downgrade. Failure to do so could result in data loss.
Downgrading from 3.1(1.95)
You need the correct target version of the software and the corresponding saved configuration before you
proceed.
1. Follow the upgrade procedure using the earlier software image.
2. Restart the hardware and check the status via the web interface.
The status report indicates the software version.
3. Restore your configuration from the saved XML file; refer to the online help for details.
Upgrading the font (optional)
Note:These instructions apply only to TelePresence Server 7010 and MSE8710 platforms. The Media
310/320 platforms always have the font pre-installed and there is no way to replace or remove it.
Your device may be shipped with the TrueType font pre-installed. You can check this on the Status or
Configuration > Upgrade page.
If the font is not present, and you want to use TrueType text rendering on your device instead of the default
text rendering method, you must upload the font file. You can get this file, called ts-font_3_0_2_48, from the
Software download page for 3.0(2.48).
Note: You should do this when the device is not heavily loaded. Also, you must use the supplied font; do not
attempt to load a different font file.
1. In a web browser, navigate to the web interface of the device.
2. Sign in as an administrator.
The username is admin and there is no password on a new unit.
3. Go to Configuration > Upgrade.
4. Under Font upgrade at New font file browse to locate the downloaded font file.
5. Select the font file.
6. Click Upload font.
After a short while, the Font file status changes to Present.
Removing the font
1. If you want to revert to the default text rendering, click Delete font.
2. Confirm that you want to remove the font file.
The Font file status changes to Not present.