Release Notes

Interoperability
Cisco TelePresence Server Software Release Notes 3.1(1.95) Page 21 of 31
Endpoint Software Comments
Cisco TelePresence System 1700 MXP F9.3.1 Tested H.323 and SIP:
n Automatic content handover does not work if
MXP tries to present immediately after another
endpoint sends content. (Issue identifier
CSCud64503)
n Under rare circumstances, corruption may be
seen when the MXP transmits content in main
video. (Issue identifier CSCuh93850)
n Under some circumstances, continuous
presence panes are cropped off the bottom of
the screen when this endpoint is receiving
CIF/4CIF resolutions. (Issue identifier
CSCuh93846)
n High motion video to the MXP 1700 can result
in repeated transient corruption. This issue is
only seen with Media 310/320 platforms, and
when the resolution sent to the endpoint is
w576p or above
Cisco TelePresence System 3000 1.10.1 Tested TIP:
n Video corruption is occasionally visible on this
endpoint after a resolution change in the
stream from the TelePresence Server. (Issue
identifier CSCui10757)
n Calls can connect at the wrong bandwidth
when SIPUPDATE messages are disabled in
the call path. For example, when routed via
Conductor, a 4MBper screen call connects at
4MB total, leaving about 1.17 MBper screen
for video. (Issue identifier CSCuh97074)
n If the conference security state changes to
insecure, and then changes back to secure,
the security indicator on this endpoint still
(incorrectly) indicates that the conference is
insecure
n You cannot disconnect audio add-in
participants via the participant list on the touch
panel. (Issue identifier CSCuj50089)
Tested CUCM to VCS H.323 interworking:
n Interworking calls from this endpoint is not
recommended
Cisco TelePresence System EX60 TC6.1.1 Tested H.323 and SIP:
n A flicker is seen when the video from a
participant changes from a continuous
presence pane into the main pane. Seen when
active speaker changes or when making a
participant important. (Issue identifier
CSCuh92611)