Maintenance Manual

Cisco TelePresence MX700 Spare Parts Replacement Guide

Loosen the screws that

fasten the clamp. Do not

remove the screws.

Gently loosen the clamp

from all mounting points

and then remove the

clamp.

Place the monitor on a stable

surface, and secure the monitor so

it is not tipping.

Use an Allen key 2.5 mm and

remove the clamp as described in

step 10b and 10c.

10a

10b

10c

Re-assemble the clamp on the new monitor:

Slide the clamp in place on the monitor and check that it is properly fitted. Locate the

support brackets; the support brackets are the loose brackets that you see between

the screws and clamp. Push the support bracket tight against the back plate of the

monitor and tighten the screws. Check that the clamp is properly fastened.

Replace monitor (wall mounted) (page 8 of 9)

Step 10: Uninstall the clamp at the rear side

Contents

Introduction

Grilles and covers

Speakers and cameras

Codec and monitors

Appendix

Codec and monitors