Maintenance Manual

Cisco TelePresence MX700 Spare Parts Replacement Guide

Replace monitor (mounted on a stand)

Spare parts:

• Left monitor for single camera system: CTS-MX700-MON-L-S= or CTS-MX700-MONLS++=

• Right monitor for single camera system: CTS-MX700-MON-R-S= or CTS-MX700-MONRS++=

• Left monitor for dual camera system: CTS-MX700-MON-L-D= or CTS-MX700-MONLD++=

• Right monitor for dual camera system: CTS-MX700-MON-R-D= or CTS-MX700-MONRD++=

The illustrations provided show how to replace the right monitor. The same steps

should be taken on the left monitor, when replacing the left monitor.

Step 1: Remove speaker grille, lower grille, loudspeakers and camera

Follow the steps described in “Replace single camera module” on page 16 to page

21; or “Replace dual camera module” on page 22 to page 28.

Note that you have to remove all loudspeakers that are mounted on the

monitor that you are replacing.

Choose Step 2 based on which of the two monitors you are going to replace:

Step 2 - When replacing the left monitor: Remove codec

Follow the steps described in “Replace codec” on page 30 to page 33.

Step 2 - When replacing the right monitor: Remove PoE injector

Follow the steps described in “Replace PoE injector” on page 34 to page 35.

Step 3: Remove center covers

Follow the steps described in “Replace center top profile, camera cover and center

back cover” on page 11 to page 12.

The monitor is heavy. We recommend

three people working together to

replace the monitor.

(page 1 of 7)

65 kg / 144 lb

Contents

Introduction

Grilles and covers

Speakers and cameras

Codec and monitors

Appendix

Codec and monitors