Maintenance Manual

Recordings on an IP VCR can be configured as H.323 endpoints. In this way, an audio-only participant can contribute
an IP VCR recording as his video stream (using the associated endpoint function, see Adding and updating users).
This function is also useful where you have a recording that you might like to view within a conference.
Refer to the table below for tips on adding an H.323 endpoint to the MCU. After entering the settings, click Add
endpoint.
Display parameters
Field Field Description Usage Tips
Name The name of the endpoint.
Call-out parameters
Field Field Description Usage Tips
Address The IP address, host name, or an
E.164 address (phone number).
You can configure this endpoint as needing to be reached via
an H.323 gateway without that gateway being already
configured on the MCU. To do this, set this field to be
<gateway address>!<E.164>. Note that square brackets are
mandatory for IPv6 addresses.
H.323
gateway
The gateway through which the
endpoint connects.
To configure a gateway on the MCU, go to Gateways. For
more information, refer to Adding and updating gateways.
97
Cisco TelePresence MCU Series Online Printable Help