Maintenance Manual

Previous participants
Refer to the table below to get details about the previous participant list. To delete this list, click Clear previous
participants record.
Field Field description Usage tips
Type Indicates whether the
participant is an H.323
, SIP, or VNC
endpoint.
Participant Displays the name of
the participant
(endpoint).
Controls
Re-connects a
participant to the
conference.
A previous participant can only be re-connected to a conference if their
endpoint is a pre-configured endpoint.
Note that if the original call to the conference was from the endpoint rather
than the endpoint being invited by the MCU, then for the MCU to recognize it,
that endpoint must be configured with Call-in match parameters. If the
MCU did not recognize that the call was from a pre-configured endpoint then
the re-connect control will not be available.
For more information about configuring endpoints on the MCU refer to
Configuring H.323 endpoints and Configuring SIP endpoints.
Status Displays the time at
which a participant
disconnected from the
conference and who
initiated the
disconnect.
Pre-Configured Participants
Refer to the table below to get details about pre-configured endpoints.
Field Field Description Usage Tips
Type Indicates whether the
participant is an H.323 , SIP,
or VNC endpoint.
Name Displays the name of the
endpoint.
Status Displays the connection
status of the pre-configured
participant.
This field shows whether the participant is pending, connected, or
disconnected, and the reason for failure if the participant has failed to
connect to the conference.
Summary Information
You may want to inform participants about conference details such as start time, and so on. Click the Summary
information icon to display further details about a conference. This information may be copied to the clipboard for
convenience.
75
Cisco TelePresence MCU Series Online Printable Help