Maintenance Manual

Mute
Mute audio from all participants (like mic.
mute).
Allow audio from all participants (like mic.
unmute)
Stop video from all participants (like camera
mute).
Allow video from all participants (like
camera unmute).
Prevent all participants from hearing the
conference (like speaker mute).
Note:The endpoints may not always detect
DTMF tones from the MCU after you mute the
audio from the MCU.
Allow all participants to hear the
conference (like speaker unmute).
Prevent all participants from seeing the
conference (like screen mute).
Allow all participants to see the conference
(like screen unmute).
Not all of the controls described here may be
present in your participant list. You can configure
which controls are shown by changing the
Participant list controls on the Settings > User
interface page (refer to Customizing the user
interface).
Disconnect
Disconnects all participants from the
conference.
If this conference was created ad hoc, then
disconnecting all the participants will terminate the
conference as well.
View
Selects voice-switched view for all
participants (see Customizing a participant's
layout view).
Selects full screen view for all participants.
Displays the layout selection panel from
which you can select a layout view that all
current participants will see. This panel offers
the same choices as going to Conferences >
Custom layout. (See Customizing layout
views).
If all participants are watching the voice-switched
view, then this control will be unavailable.
Control
Prevents participants from changing their
own view layout from their endpoint.
Allows participants to change their own
view layout from their endpoint.
If no participants may control their own view
layout, the prevent control will be unavailable. If all
participants may control their own layout, the allow
control will be unavailable.
74
Cisco TelePresence MCU Series Online Printable Help