Maintenance Manual

Mute
controls
Some of these controls are not present on the participant list by
default:
Prevent other participants from hearing this participant (like
mic. mute).
Allow other participants to hear this participant's audio (like
mic. unmute)
Prevent others from seeing this participant's video
contribution (like camera mute).
Allow others to see this participant's video contribution (like
camera unmute).
Prevent this participant from hearing the conference (like
speaker mute).
Note:The endpoint may not always detect DTMF tones from the
MCU after you mute the audio from the MCU.
Allow this participant to hear the conference (like speaker
unmute).
Prevent this participant from seeing the conference (like
screen mute).
Allow this participant to see the conference (like screen
unmute).
You can configure whether these
controls are shown by changing
the Participant list controls on
the Settings > User interface
page (refer to Customizing the
user interface).
If the controls are not configured
to be shown, and if a participant
has joined with a media channel
muted, the relevant control
appears temporarily to enable
you to unmute the channel if
required.
Disconnect
control
Disconnects a participant from the conference
You can configure the MCU to
require confirmation when
someone attempts to disconnect
an individual participant from a
conference. This setting is on the
Settings > User interface page.
68
Cisco TelePresence MCU Series Online Printable Help