Maintenance Manual

Participant controls
Floor and chair
control
Controls "Floor and chair control" settings for this
conference. The options are:
■ Do not allow floor or chair control: the use of
floor and chair controls is not allowed in this
conference
■ Allow floor control only: only floor control is
allowed in this conference; chair control is
not allowed. Any participant can 'take the
floor' so long as no other participant has
currently 'taken the floor'
■ Allow floor and chair control: both floor and
chair control are allowed in this conference.
Any participant can take the floor, and any
chairperson participant can take the chair so
long as no other participant has currently
done so
Some H.323 endpoints support a feature
known as floor and chair control that is
encompassed by the H.243 protocol. For
more information, refer to H.243 floor and
chair control.
If you change the Floor and chair control
setting for a conference currently taking
place, there will be no immediate effect.
That is, an existing floor or chair
participant will not have that status
removed.
If the unit-wide/blade-wide Floor and
chair control setting on the Global
conference settings page is set to
Disabled, it will not be possible to use floor
or chair control operations in any
conference.
For ad hoc conferences, you can
configure the Floor and chair setting
through the ad hoc conferences template.
You can also edit the Floor and chair
setting for active ad hoc conferences.
35
Cisco TelePresence MCU Series Online Printable Help