Maintenance Manual

Streaming Allow unicast and multicast streaming access to
individual conferences.
For an ad hoc conference, you can
configure Streaming through the ad hoc
conferences template. You can also
configure Streaming for active
conferences.
To use streaming, it must be enabled unit-
wide/blade-wide on the Settings >
Streaming page. See Configuring
streaming settings for additional
information.
ConferenceMe Allows you to specify on a per-conference basis
whether participants can join this conference using
ConferenceMe.
Maximum
video
participants
When the MCU is not in port reservation mode, this
parameter sets a limit on the number of endpoints
which can connect to the conference as video
participants.
A participant counts (as a single unit) towards the
video limit whether the MCU is sending a video
stream to that participant or a video stream is being
received.
If you do not want to limit the number of
participants who can join this conference
and use video, leave this field blank.
This field is only shown if the MCU is not in
port reservation mode.
This field only applies to scheduled
conferences.
Maximum
audio-only
participants
When the MCU is not in port reservation mode, this
parameter sets a limit on the number of endpoints
which can connect to the conference as audio-only
participants.
A participant counts (as a single unit) towards the
audio limit whether the MCU is sending an audio
stream to that participant or an audio stream is being
received.
If you do not want to limit the number of
participants who can join this conference
to use just audio, leave this field blank.
This field is only shown if the MCU is not in
port reservation mode.
This field only applies to scheduled
conferences.
Video ports to
reserve
In port reservation mode, this parameter specifies
the number of video ports to reserve.
A participant counts (as a single unit) towards the
video reservation value whether the MCU is sending
a video stream to that participant or a video stream is
being received.
This value is both a reservation and a limit;
the MCU guarantees that this many video
participants can connect to the
conference, but no more than this will be
able to join.
This field is only shown if the MCU is in
port reservation mode.
Audio-only
ports to
reserve
In port reservation mode, this parameter specifies
the number of audio-only ports to reserve.
A participant counts (as a single unit) towards the
audio reservation value whether the MCU is sending
an audio stream to that participant or an audio
stream is being received.
This value is both a reservation and a limit;
the MCU guarantees that this many audio-
only participants can connect to the
conference, but no more that this will be
able to join.
This field is only shown if the MCU is in
port reservation mode.
34
Cisco TelePresence MCU Series Online Printable Help