Maintenance Manual

IP Status
Use the IP status fields to verify the current IP settings for the appropriate Ethernet port of the MCU, which were
obtained using DHCP/SLAAC or configured manually (see IP configuration settings) including:
■ DHCP
■ IP address
■ Subnet mask
■ Default gateway
■ DHCPv6
■ IPv6 address
■ IPv6 default gateway
■ IPv6 link-local address
Ethernet Configuration
These settings determine the Ethernet settings for the appropriate port of the MCU. Refer to the table for assistance
with these settings. When you have finished, click Update Ethernet configuration.
Field Field Description Usage Tips
Ethernet
settings
Specify whether you want this Ethernet port
to automatically negotiate its Ethernet
settings with the device it is connected to, or
if it should use the values that you specify in
the Manual configuration fields below.
It is important that your Ethernet settings match those of
the device to which this port is connected. For example,
both devices must be configured to use automatic
negotiation, or both configured with fixed and matching
speed and duplex settings (see below).
Manual configuration
Speed Identifies the connection speed: 10 Mbit/s or
100 Mbit/s. Use automatic negotiation if a
connection speed of 1000 Mbit/s is required.
The connection speed must match that of the device to
which this port is connected.
You only need to select this option if you have chosen
Manual Ethernet settings, as described above.
Duplex Identifies the connection duplex mode:
■ Full duplex
Both devices can send data to each
other at the same time
■ Half duplex
Only one device can send to the other
at a time
The duplex setting must match that of the device to
which this port is connected.
You only need to select this option if you have chosen
Manual Ethernet settings, as described above.
Ethernet Status
Field Field description Usage tips
Link
status
Indicates whether this Ethernet port is
connected to or disconnected from the
network.
138
Cisco TelePresence MCU Series Online Printable Help