Maintenance Manual

Field Field Description More Information
Name The descriptive name of the gateway. All gateways must have a unique name.
Address The IP address or host name of the
gateway.
Note that square brackets are mandatory for IPv6
addresses.
Motion /
sharpness
trade off
Choose whether to use the unit-
wide/blade-wide setting for
motion/sharpness trade off, or configure
an individual setting for this gateway.
Choose from:
■ Use box-wide setting: this is the
default value. In this case,
connections to the gateway will
use the motion/sharpness tradeoff
setting from the Settings >
Connections page
■ Favor motion: the MCU will try and
use a high frame rate. That is, the
MCU will strongly favor a resolution
of at least 25 frames per second
■ Favor sharpness: the MCU will use
the highest resolution that is
appropriate for what is being
viewed
■ Balanced: the MCU will select
settings that balance resolution
and frame rate (where the frame
rate will not be less than 12 frames
per second)
The settings for motion (frames per second) and
sharpness (frame size or resolution) are negotiated
between the endpoint and the MCU. This setting controls
how the MCU will negotiate the settings to be used with
this endpoint.
Preferred
bandwidth
from MCU
The network capacity (measured in bits
per second) used by the media channels
established by the MCU to a single
participant.
Preferred
bandwidth
to MCU
Sets the bandwidth that the endpoint will
advertise to the MCU when it calls it.
121
Cisco TelePresence MCU Series Online Printable Help