Maintenance Manual

Related Topics
■ Configuring SIP settings
■ Configuring H.323 endpoints
■ Displaying the endpoint list
■ Configuring VNC endpoints
Configuring VNC Endpoints
You can configure a VNC (Virtual Network Computing) endpoint on the MCU by choosing Endpoints>AddVNC. This
makes it easier to add a VNC session to conferences because you can choose its name from a list rather than type its
network address.
You can add VNC endpoints to the MCU. This enables you to have software applications running on a remote
computer added to a conference. For example, if a speaker has a set of slides to present during a conference, you
can add them as a VNC endpoint. After entering the settings, click Add endpoint.
Field Field Description Usage Tips
Name The name of the computer used for the
VNC application (VNC endpoint).
Host name or
IP address
The IP address or host name of the
computer used for the VNC application
(VNC endpoint).
Note that square brackets are mandatory for IPv6
addresses.
Port The port used for communication to the
VNC endpoint.
Password The VNC server password for the
computer you're trying to view.
Re-enter
password
Re-enter the VNC password.
Automatic
disconnection
When a participant disconnects from a
conference and only endpoints set to
Automatic disconnection are left, all
those participants are disconnected.
Set to enabled if you want this endpoint to be
automatically disconnected from conferences when only
endpoints set to Automatic disconnection remain in a
conference when any other participant has
disconnected.
Related Topics
■ Displaying the endpoint list
■ Configuring H.323 endpoints
■ Configuring SIP endpoints
118
Cisco TelePresence MCU Series Online Printable Help