Maintenance Manual

Initial audio to
MCU
Select Active or Muted to define whether
audio from this endpoint should be muted
whenever it first joins a conference.
If this is Muted, then the MCU will mute the stream
whenever it successfully invites the endpoint or
recognizes the endpoint when it calls in.
Audio from preconfigured endpoints can also be
muted by the conference's Mute on join
configuration, but only when they call in. In that
case, if either the conference's Mute on join
checkbox for Audio is checked, or the endpoint's
Initial audio to MCU is Muted (or both) then the
audio from the endpoint is muted when it joins the
conference.
Initial video to
MCU
Select Active or Stopped to define whether
video from this endpoint should be stopped
whenever it first joins a conference.
If this is Stopped, then the MCU will stop the
stream whenever it successfully invites the
endpoint or recognizes the endpoint when it calls
in.
Video from preconfigured endpoints can also be
muted by the conference's Mute on join
configuration, but only when they call in. In that
case, if either the conference's Mute on join
checkbox for Video is checked, or the endpoint's
Initial video to MCU is Muted (or both) then the
video from the endpoint is stopped when it joins
the conference.
Initial audio
from MCU
Select Active or Muted to define whether
audio to this endpoint is muted whenever it
first joins a conference.
Note:The endpoint may not always detect
DTMF tones from the MCU after you mute the
audio from the MCU.
Initial video
from MCU
Select Active or Stopped to define whether
video to this endpoint is stopped whenever it
first joins a conference.
Initial
Adaptive Gain
Control
Defines whether or not the endpoint uses
Adaptive Gain Control (AGC) when it first
joins the conference. Select <use conference
configuration> to inherit the setting from the
conference. Otherwise, you can select
Enabled or Disabled to override the
conference-wide AGC setting.
Any manual changes to the participant volume will
turn AGC off for that participant. You can also
manually enable or disable AGC for a participant
that is already in the conference, on the
Conference > Participants > <Name> > Audio
page.
Automatic
disconnection
When a participant disconnects from a
conference and only endpoints set to
Automatic disconnection are left, all those
participants are disconnected.
Set to enabled if you want this endpoint to be
automatically disconnected from conferences
when only endpoints set to Automatic
disconnection remain in a conference when any
other participant has disconnected.
Custom
codec
selection
Can be used to ensure only specific codecs
are permitted on calls to (and received from)
this endpoint.
If Enabled, you can select which codecs are
allowed to be used when communicating with this
endpoint. This setting overrides the MCU-wide
codec selection on the Settings > Conference
page.
117
Cisco TelePresence MCU Series Online Printable Help