Maintenance Manual

Content
contribution
Whether this endpoint is permitted to
contribute the conference content channel.
Select from:
<use conference default>: this endpoint will
use the Content contribution from endpoints
setting from the per-conference
configuration.
Enabled: This endpoint is allowed to
contribute the content channel, even if
content contribution from endpoints is
disabled in the per-conference configuration.
Disabled: This endpoint is not allowed to
contribute the conference channel, even if
content contribution from endpoints is
enabled in the per-conference configuration.
This setting is provided to allow you to individually
configure whether or not an endpoint is allowed to
contribute content to a conference.
To use the content channel, the Content status
must be enabled at the MCU-wide level (on the
Settings > Content page) and, for any given
conference, Content mode must not be Disabled
in the conference settings.
Content
receive
Whether this endpoint is allowed to receive a
separate content stream when in a
conference.
This setting is provided to allow you to individually
configure whether or not an endpoint is allowed to
receive content from a conference.
To use the content channel, the Content status
must be enabled at the MCU-wide level (on the
Settings > Content page) and for any given
conference Content channel video must also be
enabled in the per-conference configuration.
If set to Disabled the endpoint will not receive
content or will receive the content in the normal
video channel if that setting is enabled
(Settings>Content>Display content in normal
video channel).
Note that Binary Floor Control Protocol (BFCP)
content is supported.
View border
size
Choose a border size for video transmitted to
this endpoint.
This sets a border thickness to display around the
video image. This is useful where the image is
displaying off the edges of the participant's
screen; use a border to force the image to display
properly.
Applying a border size here means that this border
size will always be used for this endpoint's
transmitted video. Note that you can also apply a
border to a participant in a conference by going to
Conferences and clicking on the name of the
conference and then altering this participant's
settings.
Default view
family
Sets the layout family to be used when calling
out to this endpoint.
If this is set to Use box-wide setting then the
default view family that has been configured via
the Conference settings page will be used.
Preferred
bandwidth
from MCU
Identifies the network capacity (measured in
bits per second) used by the media channels
established by the MCU to a single
participant.
These settings take priority over the Default
bandwidth from MCU setting configured in the
global conference settings.
113
Cisco TelePresence MCU Series Online Printable Help