Maintenance Manual

Name This must be the name that
the endpoint sends to the
MCU
The endpoint is recognized if all filled-in fields in this section are
matched. Fields left blank are not considered in the match.
When you configure Call-in match parameters, an endpoint will be
recognized as this pre-configured endpoint and the Conferencing
parameters will be applied to a call from this endpoint.
Note: call-in matching is not supported for the H.323 ID.
IPaddress The IP address of the
endpoint
E.164 The E.164 number with
which the endpoint is
registered with the
gatekeeper
Conferencing parameters
Display name
override
The name that is displayed in a conference as
a label on the video from this endpoint. It is
also the name of the endpoint as it appears
on the MCU's web interface.
The display name override is used in place of any
identifier that appears on the endpoint's video or
in the MCU's web interface. The endpoint could
otherwise be identified by its H.323 id, its E.164
number, or its IP address.
If you use only non-printing characters, such as
spaces, as a display name override, the MCU
respects this 'blank' name as a label for video from
this endpoint. In this case, the MCU does not
show the non-printing override value when listing
the endpoint in the web interface; it shows one of
the endpoint's other identifiers instead.
Note that once an endpoint has connected, you
cannot change the display name via the web
interface.
100
Cisco TelePresence MCU Series Online Printable Help