Technical References

D14 641.11 Codec C90 API Reference Guide TC6.2, JULY 2013. Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved. 192
Cisco TelePresence System Codec C90 API Reference Guide
xStatus SystemUnit State MaxNumberOfCalls
Shows the the maximum number of simultaneous calls.
Value space of the result returned:
<0..5>
Example:
xStatus SystemUnit State MaxNumberOfCalls
*s SystemUnit State MaxNumberOfCalls: 3
** end
xStatus SystemUnit State MaxNumberOfActiveCalls
Shows the the maximum number of simultaneous active calls. Calls that are set on hold/transfer are
not counted as active.
Value space of the result returned:
<0..5>
Example:
xStatus SystemUnit State MaxNumberOfActiveCalls
*s SystemUnit State MaxNumberOfActiveCalls: 3
** end
xStatus SystemUnit State NumberOfActiveCalls
Shows the number of active calls.
Value space of the result returned:
<0..5>
Example:
xStatus SystemUnit State NumberOfActiveCalls
*s SystemUnit State NumberOfActiveCalls: 0
** end
xStatus SystemUnit State NumberOfSuspendedCalls
Shows the number of suspended calls.
Value space of the result returned:
<0..5>
Example:
xStatus SystemUnit State NumberOfSuspendedCalls
*s SystemUnit State NumberOfSuspendedCalls: 0
** end
xStatus SystemUnit State NumberOfInProgressCalls
Shows the number of calls in progress.
Value space of the result returned:
<0..5>
Example:
xStatus SystemUnit State NumberOfInProgressCalls
*s SystemUnit State NumberOfInProgressCalls: 0
** end
xStatus SystemUnit State Subsystem Application
Shows the status of the sub system application.
Initialized: The sub-system application is initialized.
Initializing: The sub-system application is initializing.
Value space of the result returned:
<Initialized/Initializing>
Example:
xStatus SystemUnit State Subsystem Application
*s SystemUnit State Subsystem Application: Initialized
** end
xStatus SystemUnit ContactInfo
Returns the system's active contact information. This is the address which is used to reach this
system.
Value space of the result returned:
<String>
Example:
xStatus SystemUnit ContactInfo
*s SystemUnit ContactInfo: "[e-mail]"
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatusxStatus