Technical References

D14 641.11 Codec C90 API Reference Guide TC6.2, JULY 2013. Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved. 142
Cisco TelePresence System Codec C90 API Reference Guide
xStatus Audio Input LocalInput [1..n] AGC
Shows the AGC (Automatic Gain Control) mode on the local input.
You can run the command xStatus Audio Input LocalInput to find the identity [1..n] of the input.
Value space of the result returned:
<"O n"/"O f f ">
Example:
xStatus Audio Input LocalInput 1 AGC
*s Audio Input LocalInput 1 AGC: "On"
** end
xStatus Audio Input LocalInput [1..n] Connector
Lists the connectors that are attached to the local input.
You can run the command xStatus Audio Input LocalInput to find the identity [1..n] of the input.
Value space of the result returned:
<"Microphone.1"/../"Microphone.8"/"Line.1"/../"Line.4"/"HDMI.1"/../"HDMI.4">
Example:
xStatus Audio Input LocalInput 1 Connector
*s Audio Input LocalInput 1 Connector: "Microphone.1"
** end
xStatus Audio Input RemoteInput [1..n] CallId
Shows the CallId for the remote audio input.
You can run the command xStatus Audio Input RemoteInput to find the identity [1..n] of the input.
Value space of the result returned:
<0..65534>
Example:
xStatus Audio Input RemoteInput 8 CallId
*s Audio Input RemoteInput 8 CallId: 28
** end
xStatus Audio Output LocalOutput [1..n] Name
Shows the name of the local output.
You can run the command xStatus Audio Output LocalOutput to find the identity [1..n] of the output.
Value space of the result returned:
<String>
Example:
xStatus Audio Output LocalOutput 4 Name
*s Audio Output LocalOutput 4 Name: "MyLocalOutput1"
** end
xStatus Audio Output LocalOutput [1..n] Loudspeaker
Shows the Loudspeaker mode on the local output. If one or more of the output connectors that are
attached to the local output are connected to a loudspeaker, then this signal should be a reference
signal to the echo canceler and Loudspeaker should be set to On.
You can run the command xStatus Audio Output LocalOutput to find the identity [1..n] of the output.
Value space of the result returned:
<"O n"/"O f f ">
Example:
xStatus Audio Output LocalOutput 4 Loudspeaker
*s Audio Output LocalOutput 4 Loudspeaker: "Off"
** end
xStatus Audio Output LocalOutput [1..n] Channels
States if the local output channels are mixed into into a mono signal (1) or stereo signal (2).
You can run the command xStatus Audio Output LocalOutput to find the identity [1..n] of the output.
Value space of the result returned:
<1..2>
Example:
xStatus Audio Output LocalOutput 4 Channels
*s Audio Output LocalOutput 4 Channels: "1"
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatusxStatus