Technical References

D14642.13 Codec C40-C60 API Reference Guide TC6.3, NOVEMBER 2013. Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved. 129
Cisco TelePresence System Codec C40/C60 API Reference Guide
xCommand SystemUnit Diagnostics ExtendedLogging Start
Turns on the extended logging, which stores more information than regular logging in the log files.
You can determine the duration in seconds. Note that extended logging uses more of your video
system’s resources, and should only be used when troubleshooting an issue.
Requires user role: ADMIN
Parameters:
Duration(o): <1..600>
Example:
xCommand SystemUnit Diagnostics ExtendedLogging Start Duration: 20
OK
*r ExtendedLoggingModeResult (status=OK):
xCommand SystemUnit Diagnostics ExtendedLogging Stop
Stops the logging started with xCommand SystemUnit Diagnostics ExtendedLogging Start.
Requires user role: ADMIN
Example:
xCommand SystemUnit Diagnostics ExtendedLogging Stop
OK
*r ExtendedLoggingModeResult (status=OK):
** end
xCommand SystemUnit MenuPassword Set
Set a menu password to restrict access to Administrator Settings menu. If you have a remote
control the password can also be set from the on screen menu. If you have a Cisco TelePresence
Touch controller the menu password is set from the command line interface.
Requires user role: ADMIN
Parameters:
Password(r): <S: 0, 255>
Example:
xCommand SystemUnit MenuPassword Set Password:***********
*r MenuPasswordSetResult (status=OK):
** end
xCommand SystemUnit MenuPassword Validate
Validate that the supplied password is correct.
Requires user role: ADMIN
Parameters:
Password(r): <S: 0, 255>
Example:
xCommand SystemUnit MenuPassword Validate Password:***********
*r MenuPasswordValidateResult (status=OK):
** end
xCommand SystemUnit DateTime Set
Set the date and time for the system, if not available from NTP (Network Time Protocol).
Requires user role: ADMIN
Parameters:
Year: <2008..2037>
Mont h: <1..12>
Day: <1..31>
Hour: <0..23>
Minute: <0..59>
Second: <0..59>
Example:
xCommand SystemUnit DateTime Set Year:2012 Month:7 Day:3 Hour:12 Minute:0
Sec ond:0
*r DateTimeSetResult (status=OK):
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand