Release Notes

31
Release Notes for Cisco TelePresence System Software Release 1.10
Caveats in the CTS 1.10 Releases
Resolved Caveats in Release 1.10.11
CSCuq19232
Symptom Error messages, such as the following, for the Auxiliary Control Unit (ACU) are frequently
seen in Sysop logs:
Conditions These messages are frequently seen in sysop logs of a CTS endpoint.
Workaround There is no workaround.
CSCur48604
Symptom When Address Resolution Protocol (ARP) requests are sent to Cisco TelePresence immersive
systems, the system’s internal address (i.e. 192.168.x.1) is being returned, rather than the system’s actual
network address.
Conditions This is seen only when 802.1x is enabled.
Workaround One likely cause of the problem is an external device on the network segment that is
pinging, or sending ARP requests to the 192.168.x.1 address. So, a workaround would be to remove that
device.
CSCut10214
Symptom RTP Control Protocol (RTCP) encryption was disabled for presentation sharing.
Conditions This condition was noted when using the Binary Floor Control Protocol (BFCP) for
presentation sharing.
Workaround There is no workaround.
CSCut10506
Symptom Conference IDs are not included in the Cisco TelePresence Call MIB. In addition, scheduled
calls cannot be exported via SNMP.
Conditions These conditions are noted when using SNMP to include call information
Workaround This CDETS incorporates the following OID in the
CISCO-TELEPRESENCE-CALL-MIB.my: