Release Notes

Release Notes for Cisco TelePresence System Software Release 1.10

Supported CTS Auxiliary Devices

This section contains auxiliary devices that can be used with the CTS systems:

• Displays, page 16

• Document Cameras, page 17

• Projectors - 1.10, page 17

• Video Signal Splitters, page 18

Displays

This section describes the display choices you have with your Cisco TelePresence System and includes

the following topics:

• Qualified Cisco Displays, page 16

• Using Non-Qualified Displays With your Cisco TelePresence System, page 17

Qualified Cisco Displays

The following display is qualified for use with Cisco TelePresence System running CTS or TX software:

55-inch display, part number CTS-MON-55-WW.

Before use, turn off all on-screen display (OSD) capability for the displays. This prevents the display

from showing messages after you stop sharing a presentation.

To turn off OSD, complete the following steps.

Tip Perform these steps using the remote control that comes with the system, or use the joystick control on

the back of the display.

Step 1 Turn the display on.

Step 2 Press MENU on the remote, or press the center of the joystick and move the joystick to select the menu

option (the choice on the left), to bring up the menu for the display.

Step 3 Using the up and down arrows, navigate to System in the menu panel.

Step 4 Press Enter if using a remote, or press the center of the joystick if using the joystick on the display, to

select the System choice.

Step 5 Using the up and down arrows, navigate to General and press either Enter on the remote, or the center

of the joystick on the display.

Note This choice does not appear initially. Scroll down to see it.

Step 6 Navigate to OSD Display and press Enter or the center of the joystick.

Step 7 Set all three OSD choices (Source OSD, No Signal OSD, and MDC OSD) to Off (the default is On) to

disable OSD messages.