Release Notes

15
Release Notes for Cisco TelePresence System Software Release 1.10
Important Notes for 1.10.x Releases
– Business-to-Business Telepresence Configuration Profile Example
• Setting the Device Type
Whenever possible register your device to the Unified CM to configure the correct device type before
calibrating the camera. To perform camera calibration if your system is not registered to the Unified CM,
use the set ctstype command.
• TIP Endpoint Audio-Only Attendee not Displayed on IP Phone
When a CTS 3210, CTS 3200, CTS 3010, CTS 3000, CTS 1300-65, CTS 1100, CTS 1000, or
CTS 500-37 is in a video call with a TIP endpoint, and an additional TIP endpoint is added to the call as
a WebEx audio-only call, the audio-only TIP endpoint is not displayed in the list of users on the CTS IP
Phone.
• Touch 12 Directory Button
After system software is upgraded and the endpoint reboots, the Touch 12 device Directory button does
not show the Directory tab, only the Favorites tab. Wait 10 to 25 minutes for the Directory tab to appear.
• TMS Messaging Settings (1.10.2 and above)
If your system is integrated with TMS, see the following notes:
– Some TMS features (such as the setup buffer or meeting extension alert) are disabled by default.
These features must be enabled on the TMS administrative interface before they will work with
the Cisco TelePresence system. After you configure the features in the TMS administrative
interface, TMS updates automatically according to the interval specified in the field System
Force Refresh Interval (in hours). Alternately, you can apply your settings immediately by
navigating to Administrative Tools > Configuration > Network Settings and scrolling down
to the TMS Services area. In the field Enforce Management Settings on Systems, click
Enforce Now. If this field is set to Yes, TMS updates your system automatically when you
configure features. For more about TMS features, refer to the “New Conference” section of the
latest Cisco TelePresence Management Suite Administrator Guide.
– When you configure the setup buffer feature, then schedule a meeting, the meeting start and end
times will appear incorrect in TMS or Outlook.
– Some TMS meeting alerts and prompts may appear even when your system is not in a call.
(CSCug52535)
– When the administrator uses the TMS administrative interface to delete an active meeting, the
TelePresence system exits the meeting but still shows the scheduled meeting and the Join button
on the Touch 12. (CSCug32505)
• Viewing Presentations on Laptops
The VGA cable interface requires a 60 hertz refresh rate, but some laptops receive 60hz but do not send
60hz. For best results when viewing presentation displays on your laptop, try the following:
– Disable and re-enable sending presentation video. On IBM laptops, perform an Fn+F7 to
disable the presentation first and then use Fn+F7 to enable the presentation again. This function
is not necessary on Mac systems.
– Set the refresh rate in the monitor settings to something other than 60hz, then set it back to 60hz.
– Make sure that you have set your laptop resolution to 1024 x 768.
• Web Browser Support
The Cisco TelePresence System Administration interface is supported on Internet Explorer (IE) versions
6, 7, 8 and 9, as well as Firefox version 3.6, 5 and 9.