Release Notes

10
Release Notes for Cisco TelePresence System Software Release 1.10
What’s New
See the “Caveats in Cisco TelePresence System Software Release 1.10.2” section on page 49 for a
complete list of caveats.
New in Release 1.10.1
This release resolves system issues and enhances the user experience; there are no new features.
See the “Caveats in Cisco TelePresence System Software Release 1.10.1” section on page 52 for a
complete list of caveats.
New in Release 1.10.0
The following features are new in this release:
• 802.1X Authentication, page 10
• Dialing a URI String, page 10
• Language Versions, page 10
• Screen Dimming, page 11
• TIP Support, page 11
See the “Caveats in Cisco TelePresence System Software Release 1.10.2” section on page 49 for a
complete list of caveats.
802.1X Authentication
This software release supports the use of 802.1X authentication for port-based access control. For more
information and instructions about configuring this feature, refer to the “802.1X Authentication” section
of the Administration Guide for Cisco TelePresence Software Release 1.10.
Dialing a URI String
This software release supports using a URI string (for example, [e-mail]) to place a call. For
more information, refer to the “Dialing a URI String” section of the Cisco TelePresence System User
Guide.
Note The URI Dialing feature for CTS 1.10 endpoints is supported in Cisco Unified CM 9.0 or later.
Language Versions
This software release supports additional languages. These languages change the text that is shown on
the Cisco TelePresence Touch 12 device and also affect some on-screen messages. For more information,
refer to the “Installing Language Versions” section of the Cisco Unified Communications Manager
Configuration Guide for the Cisco TelePresence System.
Note This feature only works with systems that use the Touch 12 device for call control.