Release Notes

8 Release Notes for Cisco Small Business IP Phone SPA50X and SPA30X Firmware Version 7.4.7
Release Notes
Fixed Problems Since Firmware Version 7.4.6—Phones Used
With a Smart Phone Control Protocol (SPCP) System
This section lists fixed problems found in phones used with an SPCP call control
system; for example, the Cisco Unified Communications 500 Series (UC500)
System.
CSCtj99684 SPA30X/
SPA50X
In the SIP PUBLISH report, when Do Not Disturb is configured and a
call is forwarded, the “from” and “to” ID are incorrect.
CSCtk12261 SPA30X/
SPA50X
In the SIP PUBLISH report, the remote port reported was reported
as SIP. This has been corrected to report as RTP.
CSCtk13789 SPA30X/
SPA50X
Phone was unresponsive for two minutes while sending DNS
address lookups for an unknown SIP proxy.
Identifier Phone Model Summary
Identifier Phone Model Summary
CSCth69550 SPA50X When canceling a conference call, if canceling before dialing, user
had to manually resume call. If canceling the conference call after
dialing, the call automatically resumed. Different behavior occurs
when canceling one conference call. The fixed status is that when a
conference call is canceled, the phone will not resume the call
previously put on hold. This makes the SPA50X phones' behavior
consistent with the SPA525G's behavior.
CSCth69658 SPA301/
SPA501
Using the phone's IVR system to disable SPCP did not save the
selected mode.
CSCth71332 SPA301 Using the phone's IVR system to configure with 220 or 230 would
cause the SPA301 to immediately exit the IVR and dial the number.
CSCth71385 /
CSCti04979
SPA301/
SPA501
Cannot disable Web Server access with phone's IVR 7932#
command.
CSCth76822 SPA50X with
SPA500S
SPA500S LED button flashes red instead of orange for incoming
call.
CSCth88793 SPA30X/
SPA50X
PC port on phone did not properly change packet priority when
VLAN priority 1 was configured.