Operation Manual

Administration Settings
Management
Cisco SPA100Series Administration Guide 108
1
Cisco SPA122 Web Access fields
Cisco SPA122 Remote Access fields
Field Description
Admin Access This feature controls access to the configuration utility from
devices that are connected via the ETHERNET (LAN) port.
Click Enabled to enable this feature, or click Disabled to disable
it. The default setting is Enabled. If you administer and
configure the ATA from a computer that is connected to the
LAN, this feature must be enabled.
Web Utility Access Select the protocol to use for access to the configuration utility
from a device on the WAN. Choose HTTP and/or HTTPS. For
secure Internet access, select HTTPS. The default value is
HTTP.
Field Description
Remote Management Allows access to the configuration utility from a device that is
on the WAN side of the ATA. For example, you could connect
from another subnet in your office or from your home computer.
Click Enabled to enable this feature, or click Disabled to disable
it. The default setting is Disabled. The other fields in this section
of the page are available only if you enable this feature.
If you attempt to enable this feature while using the default
administrator login credentials, you will be prompted to change
the credentials. Click OK to acknowledge the warning message.
Use the Administration > Management > User List page to
change administrator password. For more information, see User
List (Password Management), page 112.