Operation Manual

Administration Settings
Management
Cisco SPA100Series Administration Guide 107
1
Web Access Management
Use the Administration > Management > Web Access Management page to configure the
settings for access to the administration of the ATA.
Cisco SPA112 Web Access Management fields
Access to the Cisco SPA112 configuration utility is enabled by default. Admin Access allows
you to manage the configuration from a computer in your office network, and Web Utility
Access allows you to connect from a computer on a different subnet or on the Internet. To
access the configuration utility, launch a web browser and enter the URL in the Address bar.
The URL must include the specified protocol, the WAN IP address of the ATA, and the
specified port number. For example, with the HTTPS protocol, a WAN IP address of
203.0.113.50, and port 80, you would enter: https://203.0.113.50:80
Field Description
Admin Access This feature controls access to the configuration utility from
devices that are connected via the ETHERNET (LAN) port.
Click Enabled to enable this feature, or click Disabled to disable
it. The default setting is Enabled. If you administer and
configure the ATA from a computer that is connected to the
LAN, this feature must be enabled.
Web Utility Access Select the protocol to use for access to the configuration utility
from a device on the WAN. Choose HTTP and/or HTTPS. For
secure Internet access, select HTTPS. The default value is
HTTP.
Remote Management
Port
Enter the port number to use for access to the configuration
utility from a device on the WAN. The default port number is 80.