Operation Manual

Configuring the Voice Settings
User 1 and User 2
Cisco SPA100 Series Administration Guide 102
1
Distinctive Ring Settings
Ring Settings
Media Loopback
Type
The loopback type to use when making call to request media
loopback operation. Choices are Media and Packet.
Default setting: media
Note that if the ATA answers the call, then the loopback type is
determined by the caller (the ATA always picks the first loopback
type in the offer if it contains multiple type)
CONFCID Setting Enables or disables the CONFCID.
Default setting: yes
Field Description
Ring1 - 8 Caller Caller number pattern to play Distinctive Ring/CWT 1, 2, 3, 4, 5,
6, 7, or 8. Caller number patterns are matched from Ring 1 to Ring
8. The first match (not the closest match) will be used for alerting
the subscriber. The distinctive rings are set on the Regional page.
Default setting: blank
Field Description
Default Ring Default ringing pattern, 1–8, for all callers.
Default setting: 1
Default CWT Default CWT pattern, 1–8, for all callers.
Default setting: 1
Hold Reminder Ring Ring pattern for reminder of a holding call when the phone is on-
hook.
Default setting: 8
Call Back Ring Ring pattern for call back notification.
Default setting: 7
Cfwd Ring Splash
Len
Duration of ring splash when a call is forwarded (0 – 10.0s)
Default setting: 0
Cblk Ring Splash
Len
Duration of ring splash when a call is blocked (0 – 10.0s)
Default setting: 0
Field Description