Operation Manual

Configuring the Voice Settings

User 1 and User 2

Cisco SPA100 Series Administration Guide 101

Secure Call Setting If yes, all outbound calls are secure calls by default, without

requiring the user to dial a star code first.

Default setting: no

• If Secure Call Setting is set to yes, all outbound calls are

secure. However, a user can disable security for a call by

dialing *19 before dialing the target number.

• If Secure Call Setting is set to No, the user can make a

secure outbound call by dialing *18 before dialing the

target number.

• A user cannot force inbound calls to be secure or not

secure; that depends on whether the caller has security

enabled or not.

Note: This setting is applicable only if Secure Call Serv is set to

yes on the line interface. See Line 1 and Line 2 Settings (PHONE

1 and PHONE 2), page 80.

Message Waiting Setting this value to yes can activate stutter tone and VMWI

signal. This parameter is stored in long term memory and will

survive after reboot or power cycle.

Default setting: no

Accept Media

Loopback Request

Controls how to handle incoming requests for loopback operation.

Default setting: automatic

• never: Never accepts loopback calls; replies 486 to the

caller.

• automatic: Automatically accepts the call without ringing.

• manual: Rings the phone first, and the call must be picked

up manually before loopback starts.

Default setting: Automatic

Media Loopback

Mode

The loopback mode to assume locally when making call to request

media loopback. Choices are: Source and Mirror.

Default setting: source

NOTE If the ATA answers the call, the mode is determined by the

caller.

Field Description