Operation Manual

Getting Started

Configuration and Management of the ATA

Cisco SPA100 Series Administration Guide 14

Configuration and Management of the ATA

You can use the web-based configuration utility to set up your ATA. You also can use the built-

in Interactive Voice Response (IVR) system.

Using the Web-Based Configuration Utility

STEP 1 Connect your computer to the same subnet as the ATA. For example, if the ATA is connected

to a LAN port on your router, also connect your computer to a LAN port on your router.

Note: On SPA122, you can connect your computer to the ETHERNET (Yellow) port of the

ATA.

STEP 2 Power on your computer.

NOTE: Make sure your computer’s Ethernet adapter is set to obtain an IP address

automatically. For more information, refer to the Help for your operating system.

STEP 3 Start a web browser on your computer.

STEP 4 In the Address bar, enter the IP address of the ATA.

• SPA112: Use the ATA’s IVR or your router’s configuration utility to find the

dynamically assigned IP address of the ATA. For information about the IVR, see Using

the IVR for Administration, page 15.

• SPA122: In the Address bar, enter: 192.168.15.1

Note: 192.168.15.1 is the default local IP address of the ATA.

STEP 5 To log in for the first time, enter the default username, admin, and the default password,

admin. The password is case sensitive.

STEP 6 Enter the Connection Type and settings required by your Internet Service Provider. Types

include DHCP (the default option), Static IP, and PPPoE (required for most DSL service).

After entering these settings, click Submit to establish your Internet connection.

STEP 7 Use the menus to configure your settings, as needed.