Operation Manual

Configuring the Voice Settings
Line 1 and Line 2 Settings (PHONE 1 and PHONE 2)
Cisco SPA100 Series Administration Guide 92
1
Three Way Conf Serv Enable Three Way Conference Service. Three Way Conference is
required for Attended Transfer.
Default setting: yes
Attn Transfer Serv Enable Attended Call Transfer Service. Three Way Conference is
required for Attended Transfer.
Default setting: yes
Unattn Transfer Serv Enable Unattended (Blind) Call Transfer Service.
Default setting: yes
MWI Serv Enable MWI Service. MWI is available only if a Voice Mail
Service is set-up in the deployment.
Default setting: yes
VMWI Serv Enable VMWI Service (FSK)
Default setting: yes
Speed Dial Serv Enable Speed Dial Service.
Default setting: yes
Secure Call Serv Secure Call Service. If this feature is enabled, a user can make a
secure call by entering an activation code (*18 by default) before
dialing the target number. Then audio traffic in both directions is
encrypted for the duration of the call.
Default setting: yes
Star codes are set in Vertical Service Activation Codes. To enable
secure calling by default, without requiring a star code, set the
user’s Secure Call Setting to yes. See User 1 and User 2, page 98.
Referral Serv Enable Referral Service. See the Referral Services Codes
parameter For more information.
Default setting: yes
Feature Dial Serv Enable Feature Dial Service. See the Feature Dial Services Codes
parameter For more information.
Default setting: yes
Service
Announcement Serv
Enable Service Announcement Service.
Default setting: no
Reuse CID Number
As Name
Use the Caller ID number as the caller name.
Default settings: yes
Field Description