Operation Manual

Configuring the Voice Settings
Line 1 and Line 2 Settings (PHONE 1 and PHONE 2)
Cisco SPA100 Series Administration Guide 86
1
Call Feature Settings
Field Description
Blind Attn-Xfer
Enable
Enables the ATA to perform an attended transfer operation by
ending the current call leg and performing a blind transfer of the
other call leg. If this feature is disabled, the ATA performs an
attended transfer operation by referring the other call leg to the
current call leg while maintaining both call legs. To use this
feature, select yes. Otherwise, select no.
Default setting: no
MOH Server User ID or URL of the auto-answering streaming audio server.
When only a user ID is specified, the current or outbound proxy is
contacted. Music-on-hold is disabled if the MOH Server is not
specified.
Default setting: blank
Xfer When Hangup
Conf
Makes the ATA perform a transfer when a conference call has
ended. Select yes or no from the drop-down menu.
Default setting: yes
Conference Bridge
URL
This feature supports external conference bridging for n-way
conference calls (n>2), instead of mixing audio locally. To use this
feature, set this parameter to that of the server's name. For
example: [e-mail]:12345 or conf (which uses the
Proxy value as the domain).
Default setting: blank
Conference Bridge
Ports
Select the maximum number of conference call participants. The
range is 3 to 10.
Default setting: 3
Enable IP Dialing Enable or disable IP dialing. If IP dialing is enabled, one can dial
[userid@] a.b.c.d[:port], where ‘@’, ‘.’, and ‘:’ are dialed by
entering *, user-id must be numeric (like a phone number) and a, b,
c, d must be between 0 and 255, and port must be larger than 255.
If port is not given, 5060 is used. Port and User-Id are optional. If
the user-id portion matches a pattern in the dial plan, then it is
interpreted as a regular phone number according to the dial plan.
The INVITE message, however, is still sent to the outbound proxy
if it is enabled.
Default setting: no