Operation Manual

Configuring the Voice Settings
Line 1 and Line 2 Settings (PHONE 1 and PHONE 2)
Cisco SPA100 Series Administration Guide 80
1
Line 1 and Line 2 Settings (PHONE 1 and PHONE 2)
Use the Voice > Line 1 and Voice > Line 2 pages to configure the settings for calls through the
PHONE 1 and PHONE 2 ports.
Enter the settings as described below. After making changes, click Submit to save your
settings, or click Cancel to redisplay the page with the saved settings.
NOTE In a configuration profile, the FXS parameters must be appended with the appropriate numeral
(for example, [1] or [2]) to identify the port to which the setting applies.
General
Streaming Audio Server (SAS)
Field Description
Line Enable To enable this line for service, select yes. Otherwise, select no.
Default setting: yes
Field Description
SAS Enable To enable the use of the line as a streaming audio source, select
yes. Otherwise, select no. If enabled, the line cannot be used for
outgoing calls. Instead, it auto-answers incoming calls and streams
audio RTP packets to the caller.
Default setting: no
SAS DLG Refresh
Intvl
If this value is not zero, it is the interval at which the streaming
audio server sends out session refresh (SIP re-INVITE) messages
to determine whether the connection to the caller is still active. If
the caller does not respond to the refresh message, the ATA ends
this call with a SIP BYE message. The range is 0 to 255 seconds (0
means that the session refresh is disabled)
Default setting: 30