Operation Manual

Configuring the Voice Settings
Regional
Cisco SPA100 Series Administration Guide 77
1
Conference Act Code If this code is specified, the user must enter it before dialing the
third party for a conference call. Enter the code for a conference
call.
Default setting: blank
Attn-Xfer Act Code If the code is specified, the user must enter it before dialing the
third party for a call transfer. Enter the code for a call transfer.
Default setting: blank
Modem Line Toggle
Code
Toggles the line to a modem. Modem passthrough mode can be
triggered only by pre-dialing this code.
Default setting: *99
FAX Line Toggle
Code
Toggles the line to a fax machine.
Default setting: #99
Media Loopback
Code
Use for media loopback.
Default setting: *03
Referral Services
Codes
These codes tell the ATA what to do when the user places the
current call on hold and is listening to the second dial tone.
One or more *codes can be configured into this parameter, such as
*98, or *97|*98|*123, etc. The maximum length is 79 characters.
This parameter applies when the user places the current call on
hold by pressing the hook flash button. Each *code (and the
following valid target number according to current dial plan)
triggers the ATA to perform a blind transfer to a target number that
is prepended by the service *code.
For example, after the user dials *98, the ATA plays a special dial
tone called the Prompt Tone while waiting for the user the enter a
target number (which is checked according to dial plan as in
normal dialing). When a complete number is entered, the ATA
sends a blind REFER to the holding party with the Refer-To target
equal to *98 target_number. This feature allows the ATA to hand
off a call to an application server to perform further processing,
such as call park.
The *codes should not conflict with any of the other vertical
service codes internally processed by the ATA. You can empty the
corresponding *code that you do not want the ATA to process.
Default setting: blank
Field Description