Operation Manual

Configuring the Voice Settings

Regional

Cisco SPA100 Series Administration Guide 73

Interdigit Long Timer Long timeout between entering digits when dialing. The interdigit

timer values are used as defaults when dialing. The

Interdigit_Long_Timer is used after any one digit, if all valid

matching sequences in the dial plan are incomplete as dialed.

Range: 0–64 seconds.

Default setting: 10

Interdigit Short

Timer

Short timeout between entering digits when dialing. The

Interdigit_Short_Timer is used after any one digit, if at least one

matching sequence is complete as dialed, but more dialed digits

would match other as yet incomplete sequences. Range: 0–64

seconds.

Default setting: 3

CPC Delay Delay in seconds after caller hangs up when the ATA starts

removing the tip-and-ring voltage to the attached equipment of the

called party. The range is 0–255 seconds. This feature is generally

used for answer supervision on the caller side to signal to the

attached equipment when the call has been connected (remote end

has answered) or disconnected (remote end has hung up) This

feature should be disabled for the called party (in other words, by

using the same polarity for connected and idle state) and the CPC

feature should be used instead.

Without CPC enabled, reorder tone will is played after a

configurable delay. If CPC is enabled, dial tone will be played

when tip-to-ring voltage is restored. Resolution is 1 second.

Default setting: 2

CPC Duration Duration in seconds for which the tip-to-ring voltage is removed

after the caller hangs up. After that, tip-to-ring voltage is restored

and the dial tone applies if the attached equipment is still off-hook.

CPC is disabled if this value is set to 0. Range: 0 to 1.000 second.

Resolution is 0.001 second.

Default setting: 0.5

Field Description