Operation Manual

Configuring the Voice Settings
Regional
Cisco SPA100 Series Administration Guide 72
1
Control Timer Values (sec)
Synchronized Ring If this is set to yes, when the ATA is called, all lines ring at the
same time (similar to a regular PSTN line) After one line answers,
the others stop ringing.
Default setting: no
Field Description
Hook Flash Timer
Min
Minimum on-hook time before off-hook qualifies as hook flash.
Less than this the on-hook event is ignored. Range: 0.1–0.4
seconds.
Default setting: 0.1
Hook Flash Timer
Max
Maximum on-hook time before off-hook qualifies as hook flash.
More than this the on-hook event is treated as on hook (no hook-
flash event) Range: 0.4–1.6 seconds.
Default setting: 0.9
Callee On Hook
Delay
Phone must be on-hook for at this time in sec. before the ATA will
tear down the current inbound call. It does not apply to outbound
calls. Range: 0–255 seconds.
Default setting: 0
Reorder Delay Delay after far end hangs up before reorder tone is played. 0 =
plays immediately, inf = never plays. Range: 0–255 seconds.
Default setting: 5.
Call Back Expires Expiration time in seconds of a call back activation. Range: 0–
65535 seconds.
Default setting: 1800
Call Back Retry Intvl Call back retry interval in seconds. Range: 0–255 seconds.
Default setting: 30
Call Back Delay Delay after receiving the first SIP 18x response before declaring
the remote end is ringing. If a busy response is received during this
time, the ATA still considers the call as failed and keeps on
retrying.
Default setting: 0.5
VMWI Refresh Intvl Interval between VMWI refresh to the device.
Default setting: 0
Field Description