Operation Manual

Configuring the Voice Settings
Regional
Cisco SPA100 Series Administration Guide 68
1
SIT1 Tone Alternative to the Reorder Tone played when an error occurs as a
caller makes an outbound call. The RSC to trigger this tone is
configurable on the SIP screen.
Default setting: 985@-16,1428@-16,1777@-16;20(.380/0/1,.380/
0/2,.380/0/3,0/4/0)
SIT2 Tone Alternative to the Reorder Tone played when an error occurs as a
caller makes an outbound call. The RSC to trigger this tone is
configurable on the SIP screen.
Default setting: 914@-16,1371@-16,1777@-16;20(.274/0/1,.274/
0/2,.380/0/3,0/4/0)
SIT3 Tone Alternative to the Reorder Tone played when an error occurs as a
caller makes an outbound call. The RSC to trigger this tone is
configurable on the SIP screen.
Default setting: 914@-16,1371@-16,1777@-16;20(.380/0/1,.380/
0/2,.380/0/3,0/4/0)
SIT4 Tone Alternative to the Reorder Tone played when an error occurs as a
caller makes an outbound call. The RSC to trigger this tone is
configurable on the SIP screen.
Default setting: 985@-16,1371@-16,1777@-16;20(.380/0/1,.274/
0/2,.380/0/3,0/4/0)
MWI Dial Tone Played instead of the Dial Tone when there are unheard messages
in the caller’s mailbox.
Default setting: 350@-19,440@-19;2(.1/.1/1+2);10(*/0/1+2)
Cfwd Dial Tone Played when all calls are forwarded.
Default setting: 350@-19,440@-19;2(.2/.2/1+2);10(*/0/1+2)
Holding Tone Informs the local caller that the far end has placed the call on hold.
Default setting: 600@-19;*(.1/.1/1,.1/.1/1,.1/9.5/1)
Conference Tone Played to all parties when a three-way conference call is in
progress.
Default setting: 350@-19;20(.1/.1/1,.1/9.7/1)
Secure Call
Indication Tone
Played when a call has been successfully switched to secure mode.
It should be played only for a short while (less than 30 seconds)
and at a reduced level (less than -19 dBm) so it does not interfere
with the conversation.
Default setting: 397@-19,507@-19;15(0/2/0,.2/.1/1,.1/2.1/2)
Field Description