Operation Manual

Configuring the Voice Settings
Regional
Cisco SPA100 Series Administration Guide 67
1
Call ProgressTones
Field Description
Dial Tone Prompts the user to enter a phone number. Reorder Tone is played
automatically when Dial Tone or any of its alternatives times out.
Default setting: 350@-19,440@-19;10(*/0/1+2)
Second Dial Tone Alternative to the Dial Tone when the user dials a three-way call.
Default setting: 420@-19,520@-19;10(*/0/1+2)
Outside Dial Tone Alternative to the Dial Tone. It prompts the user to enter an
external phone number, as opposed to an internal extension. It is
triggered by a comma character encountered in the dial plan.
Default setting: 420@-16;10(*/0/1)
Prompt Tone Prompts the user to enter a call forwarding phone number.
Default setting: 520@-19,620@-19;10(*/0/1+2)
Busy Tone Played when a 486 RSC is received for an outbound call.
Default setting: 480@-19,620@-19;10(.5/.5/1+2)
Reorder Tone Played when an outbound call has failed, or after the far end hangs
up during an established call. Reorder Tone is played automatically
when Dial Tone or any of its alternatives times out.
Default setting: 480@-19,620@-19;10(.25/.25/1+2)
Off Hook Warning
Tone
Played when the caller has not properly placed the handset on the
cradle. Off Hook Warning Tone is played when the Reorder Tone
times out.
Default setting: 480@-10,620@0;10(.125/.125/1+2)
Ring Back Tone Played during an outbound call when the far end is ringing.
Default setting: 440@-19,480@-19;*(2/4/1+2)
Ring Back 2 Tone Your ATA plays this ringback tone instead of Ring Back Tone if
the called party replies with a SIP 182 response without SDP to its
outbound INVITE request.
Default setting: the same as Ring Back Tone, except the cadence is
1s on and 1s off.
Default setting: 440@-19,480@-19;*(1/1/1+2)
Confirm Tone Brief tone to notify the user that the last input value has been
accepted.
Default setting: 600@-16;1(.25/.25/1)