Operation Manual

Configuring the Voice Settings

Provisioning

Cisco SPA100 Series Administration Guide 63

Firmware Upgrade

Report Rule The target URL to which configuration reports are sent. This

parameter has the same syntax as the Profile_Rule parameter, and

resolves to a TCP/IP command with an associated URL.

A configuration report is generated in response to an authenticated

SIP NOTIFY message, with Event: report. The report is an XML

file containing the name and value of all the device parameters.

This parameter may optionally contain an encryption key. For

example:

[ --key $K ] tftp://ps.callhome.net/$MA/rep.xml.enc

Default setting: blank

Field Description

Upgrade Enable Determines whether or not firmware upgrade operations can occur

independently of resync actions.

Default setting: yes

Upgrade Error Retry

Delay

The upgrade retry interval (in seconds) applied in case of upgrade

failure. The ATA has a firmware upgrade error timer that activates

after a failed firmware upgrade attempt. The timer is initialized

with the value in this parameter. The next firmware upgrade

attempt occurs when this timer counts down to zero.

Default setting: 3600

Downgrade Rev

Limit

Enforces a lower limit on the acceptable version number during a

firmware upgrade or downgrade. The ATA does not complete a

firmware upgrade operation unless the firmware version is greater

than or equal to this parameter.

Default setting: blank

Upgrade Rule This parameter is a firmware upgrade script with the same syntax

as Profile_Rule. Defines upgrade conditions and associated

firmware URLs.

Default setting: blank

Log Upgrade Request

Msg

Syslog message issued at the start of a firmware upgrade attempt.

Default setting: $PN $MAC -- Requesting upgrade $SCHEME://

$SERVIP:$PORT$PATH

Field Description