Operation Manual

Configuring the Network

Advanced Settings

Cisco SPA100Series Administration Guide 33

Time Zone

To use a time server to establish the time settings, select Time Zone. Then complete the fields

in this section.

Advanced Settings

Use the Network Setup > Advanced Settings pages to configure features including port flow

control, MAC address cloning, VPN passthrough, and VLAN.

• Port Setting (SPA122 Only)

• MAC Address Clone (SPA122 Only)

• VPN Passthrough (SPA122 Only)

•VLAN

• CDP & LLDP

Field Description

Time Zone Choose the time zone for the site where the ATA is in operation.

Default setting: (GMT-08:00) Pacific Time (USA & Canada)

Adjust Clock for

Daylight Saving

Changes

Check the box if you want to automatically adjust the time when

Daylight Savings Time is in effect. Otherwise, uncheck the box.

Default setting: Enabled

Time Server Address To use the ATA’s default Network Time Protocol (NTP) server,

select Auto from the drop-down list. This is the default setting.

If you want to specify the NTP server, select Manual, and then

enter the NTP server address.

Default setting: Auto

Resync Timer Enter the Resync timer interval value (in seconds). This timer

controls how often the ATA resynchronizes with the NTP server.

Default setting: 3600 seconds

Auto Recovery After

Reboot

Choose this option to allow the ATA to automatically reconnect

to the time server after a system reboot.

Default setting: Disabled