Operation Manual

Configuring the Network
Basic Setup
Cisco SPA100Series Administration Guide 31
1
Option 66 Provides provisioning server address information to hosts that
request this option. Server information can be defined in one of
three ways:
• None: The ATA uses its own TFTP server to source
provisioning files, so it returns its own local IP address
to the client.
• Remote TFTP Server: The ATA was configured by using
this method, and received server information through
Option 66 on its WAN interface. In response to client
requests, it provides the remote TFTP server
information.
• Manual TFTP Server: Allows the manual configuration
of a configuration server address. While this option is
typically used to provide either an IP address or a fully
qualified hostname, the ATA will also accept and offer a
full URL including protocol, path and filename to meet
to requirements of specific clients.
Default setting: None
TFTP Server If you chose Manual TFTP Server for Option 66, enter the IP
address, hostname, or URL of the TFTP server that is used to
configure the ATA.
Default setting: blank
Option 67 Provides a configuration/bootstrap filename to hosts that request
this option. This option is used in conjunction with option 66 to
allow a client to form an appropriate TFTP request for the file.
Default setting: blank
Option 159 Provides a configuration URL to clients that request this option.
An option 159 URL defines the protocol and path information
by using an IP address for clients that cannot use DNS. For
example:
https://10.1.1.1:888/configs/bootstrap.cfg
Default setting: blank
Field Description