Operation Manual

Configuring the Network
Basic Setup
Cisco SPA100Series Administration Guide 26
1
traversal is required, either on the ATA or another network device. Use this option if
your ATA connects to one network on the WAN port (10.0.0.0 for example) and to
another network on the LAN port (192.168.0.0 for example). This option is selected by
default and is suitable for most deployments.
• Bridge: Bridged mode is used if the ATA is acting as a bridge device to another router.
Choose this option if your ATA bridges a network (10.0.0.0 for example) to its LAN
port (with connected devices also in the 10.0.0x range).
Internet Settings
Use the Network Setup > Basic Setup > Internet Settings page to set up your Internet
connection.
Enter the settings as described in the table. After making changes, click Submit to save your
settings, or click Cancel to redisplay the page with the saved settings.
Internet Connection Type
Field Description
Connection Type Specify the Internet addressing method that your ISP requires.
Default setting: Automatic Configuration - DHCP
• Automatic Configuration - DHCP: Use this setting if
your ISP dynamically provides an IP address. No
additional settings are required on this page.
• Static IP: Use this setting if your ISP assigned a static/
permanent IP address. Complete the fields that appear.
See more information below.
• PPPoE (DSL service): Some DSL-based ISPs use PPPoE
(Point-to-Point Protocol over Ethernet) to establish
Internet connections. If you are connected to the Internet
through a DSL line, check with your ISP to see if they
use PPPoE. Complete the fields that appear. See more
information below.