Operation Manual

Administration Settings
Factory Defaults
Cisco SPA100Series Administration Guide 119
1
Traceroute Test
Use the Administration > Diagnostics > Traceroute page to view the route between the ATA
and a destination.
STEP 1 Enter the IP address or domain name of the destination.
STEP 2 Click Start to Traceroute to start the test. The results appear on the page and are refreshed
every 5 seconds. During the test, you can click Stop to abandon the test.
The results display up to 30 hops.
STEP 3 Click Close to close the results and display the Traceroute Test form.
Factory Defaults
Use the Administration > Factory Defaults page to reset the ATA to the default configuration.
Alternatively, press and hold the RESET button for 20 seconds. All user-changeable non-
default settings will be lost. This may include network and service provider data.
You can perform the following tasks:
• Restore Router Factory Defaults: Choose Yes to remove any custom data (router)
settings that you have configured. The default settings will be restored when you click
Submit.
• Restore Voice Factory Defaults: Choose Yes. to remove any custom settings that you
configured on the Voice pages of the configuration utility. The default settings will be
restored when you click Submit.