Operation Manual

Administration Settings
Logging
Cisco SPA100Series Administration Guide 116
1
Log Setting
If logging is enabled on the Administration > Log > Log Module page, the ATA can
periodically send the log file to a server or to an email address. Use the Log Setting page to
enter the information for your syslog server and email account.
NOTE For information about enabling and configuring logging, see Log Module, page 114.
Enter the settings as described below. After making changes, click Submit to save your
settings, or click Cancel to redisplay the page with the saved settings.
Local
Syslog Server
E-Mail
When logging is enabled, you can send logs to an email address by using SMTP.
NOTE Service providers’ requirements vary. Be aware that some providers do not allow SMTP email
from a free account. Other providers may require a user to log on to a new mailbox before
sending emails. For accurate information, read the support documentation from your provider.
In your provider's support or help system, search for information about SMTP server settings.
Field Description
Log Size Enter the maximum size of the log file in kilobytes. Valid values
are from 128 to 1024.
Field Description
IP Address Enter the IP address of the syslog server where the messages
will be sent.
Port Enter the port to use on the server. Valid values are from 1 to
65535.
Field Description
Sender If you wish to send log entries to an email account, complete all
of the fields in this section. Enter a valid email address to
identify the sender of the email. Example: [e-mail]