Operation Manual

Administration Settings

Logging

Cisco SPA100Series Administration Guide 113

• Old Password (administrator account only): Enter the existing password. The default

administrator password is admin. The default guest password is cisco.

• New Password: Enter up to 32 characters for your new password.

• Confirm New Password: Enter the new password again, to confirm.

STEP 3 After making changes, click Submit to save your settings, or click Cancel to redisplay the page

with the saved settings.

Bonjour

Use the Administration > Management > Bonjour page to enable or disable Bonjour. Bonjour

is a service discovery protocol that locates network devices such as computers and servers on

your LAN. It may be required by network management systems that you use. When this

feature is enabled, the ATA periodically multicasts Bonjour service records to its entire local

network to advertise its existence.

Click Enabled to enable this feature, or click Disabled to disable it. The default setting is

Enabled. After making changes, click Submit to save your settings, or click Cancel to

redisplay the page with the saved settings.

Reset Button

Click Enabled to enable the reset button, or click Disabled to disable it. The default setting is

Enabled. After making changes, click Submit to save your settings, or click Cancel to

redisplay the page with the saved settings.

Logging

The ATA allows you to record incoming, outgoing, and DHCP lists for various events that

occur on your network.The Incoming Log displays a temporary list of the source IP addresses

and destination port numbers for the incoming Internet traffic. The Outgoing Log displays a

temporary list of the local IP addresses, destination URLs/IP addresses, and service/port

numbers for the outgoing Internet traffic.

See these topics:

• Log Module

• Log Setting