User Guide

Chapter 3 Installation and General Operation
RFGW1 Bulk Provisioning
The RPU provides a bulk provisioning feature to configure specific settings on one
or more RFGW1s. This provisioning is accomplished via SNMP and does not require
the system to reboot.
Set Port Power/Port Control Levels (Step 3a)
This feature provides a mechanism to bulk provision one or more of the RFGWs RF
port power/port control levels.
Follow the instructions below.
1 From the
Hub List, select desired Hub.
All units configured for this Hub are displayed. Result:
2 From the
Select RFGW box, select the unit for which you would like to set
power/port control levels.
Note: To display data for more than one unit, hold down the <ctrl> key and click
an additional list element, or hold down the <shift> key to select a range of units.
3 In the
Select Ports box, click the port to configure.
4 To set the port power level, enter the port power setting (in db) in the box and
click the
Set Power is Active box.
5 To set the port control setting, click the drop-down box and select
on or off. Click
the
box. Set Port Control is Active
.
6 Click
Send Update
30 4035993 Rev A