User Guide

Chapter 3 Installation and General Operation
Programming the RFGW1 with Configuration Database (Phase 2 Step 2c)
Follow the instructions below to program RFGW1s with the Configuration
databases.
Note: There are two options for programming a list of RFGW1s. These options are
configured using the
Configure menu.
1 Select
RFGW Reboot Options and Limits.
The following options are available:
 Asynchronous - Programs each RFGW1 and does not wait for the unit to
reboot. The unit will be continuously pinged until it responds. The ping
status displays the IP addresses and their response status. This is the default
mode.
 Synchronous - Programs each RFGW1 and waits for each unit to reboot.
Note: For multiple units, it is likely that the user will prefer to select the
Asynchronous mode.
2 From the
Hub List window, select the desired Hub.
All units configured for this HUB are displayed. Result:
26 4035993 Rev A