User Guide

3-3
Cisco AlarmTracker Client User Guide
OL-1501-01
Chapter 3 Getting Started
Connecting to an LGMapper Server
Note Not any computer is an allowable choice to select. The server must have a
properly registered copy of the LGMapper COM server. If these machines do
not, then the connection will fail.
If you enter the names of two valid servers, AlarmTracker Client will attempt to
make a connection to both of them, but only one connection can be the active one.
During connection, an attempt is first made to make the first Server name the
active connection.
The connection process may be almost instantaneous, or it may take a few seconds
to a few minutes to connect depending on the state of the LGMapper server, the
number of customers supported, and the speed of your network. During the
connection process, the Connect to LGMapper Servers dialog expands to show the
status of the connection as it happens. During connection, the dialog looks similar
to Figure 3-2.