Manualshelf

Release Notes

ManualsBrandsCisco ManualsData Center Network ManagerCisco Prime Data Center Network Manager 6.1
11121314151617181920
16
Cisco Prime DCNM Release Notes, Release 7.0.(2)
OL-31385-01
Caveats
Open Caveats—Cisco DCNM Release 7.0.(2)
This section lists caveats that apply to both Cisco DCNM-LAN and Cisco DCNM-SAN.
• CSCuf73759
Symptom: The two layer VPC id is not shown on topology pane and links do not display correctly
on Topology--> port channel and VPC view.
Conditions: When you discover the two n5k and n1k one by one with hop 0.
Workaround: Discover all the devices (2N5ks and 1 n1k) in one task Or rediscover the 2 uplink
N5ks one by one.
• CSCul88797
Symptom: Connection between Fex and N1k not shown for 2 layer vPC.
Conditions: When using 2 layer vPC setup, the connection between the Fex and N1k is not shown.
This is a rare occurrence.
Workaround: Discover the devices in 2 layer vPC serially, one after the other.
• CSCun86190
Symptom: While generating a POAP, the value of the last column in the array type parameters do
not get modified.
Conditions: On opening the pop-up to modify the array type parameters, the last column still
displays the default value. All the other columns and the non-array type parameters are updated with
the modified values.
Workaround: Do not open the pop-up to modify the array type parameters, you can directly edit
the parameters in-line.
Resolved Caveats—Cisco DCNM Release 7.0.(2)
This section lists caveats that apply to both Cisco DCNM-LAN and Cisco DCNM-SAN.
• CSCum62685
Symptom: From POAP definitions, when you edit a definition, follows all the steps, publishes it,
and then tries to view the DFA topology, the screen is blank and unresponsive.
The same issue occurs when POAP definition is saved and published and, then you navigate to the
DFA screen.
Conditions: When the POAP definition is saved or edited and published and, then you view the DFA
topology screen.
Workaround: You must reload/refresh the browser to resolve this issue.
• CSCul07068
Symptom: When a switch is discovered, the mgmt0 interface is not shown in the Interface listing
page for the switch.
Conditions: Always.
Workaround: None.